logo
Painting Advice and Premium Products from Experienced Professionals.
Installing the Foam Rail.
   

Set up your barrier. Set up a ZipWall® barrier in desired configuration with the poles at least five feet apart. Allow four extra inches of plastic to overlap the head at the top of each poles.
Each Foam Rail requires the use of one ZipWall® pole and jack with the head and plate removed. Simply pull the head straight up and off.
Set up the Foam Rail. Holding the T-Clip in your hand with the socket away from your palm, squeeze the clip open. Place the Foam Rail into position and release the pressure. T-Clip will grab the Foam Rail.



Attach the T-Clip to the Foam Rail approximately where the label is to center it. The T-Clip will fit anywhere along the Foam Rail.Snap the T-Clip and Foam Rail on the ball at the top of the ZipWall® pole and jack.





Now, with the Foam Rail attached to the pole, raise it into place, pressing the plastic barrier against the ceiling.
   

Fits any length. With multiple Foam Rails you can seal any span.
The Foam Rail easily overlaps each other allowing you to adjust to any barrier length.
   

Customize. If you need to create a custom length of Foam Rail, cut the aluminum and foam to the desired size using a hacksaw. Remove the plastic end from the discarded length of Foam Rail by pulling it straight out using pliers. Then press this plastic end into the newly cut Foam Rail.